niomcb.blogg.se - X041 sentry safe open

If you pause longer, an error signal will occur (blinking red light and three beeps), indicating you should start over. The lock allows 5 seconds for each key press. A green PROCEED light and a single beep indicate that the keypad “felt” your touch.

For units with key, turn the key to the right.

(Be sure key lock is turned as far left as possible.)

Insert the four-bitted key into the lock to the left of the key pad.

Some electronic units are equipped with a handle OR electronic lock and key. NOTE: All electronic lock units have been provided with an override key (skeleton key).

Test your combination several times with the door open. (See back cover of this manual for your factory code.)

B) Insert the four batteries as indicated. Remove key hook plate located on the inside back of the door by sliding the plate upward, then pulling toward you. A) Unlock door with the override key provided in the plastic bag attached to the owner’s manual, and open the door using the lever handle. To install batteries, remove keypad by rotating the cover counterclockwise, then pulling toward you.